One of the most common household chores is taking care of your driveway. After all, it’s where you park and walk or drive to get things from the carport! But did you know that motor oil can be left on these surfaces if not properly cleaned?
The best way to remove motor oil from your driveway is with a pressure washer. This will thoroughly clean it and get rid of any remaining stains, making sure that you’ll never have an issue like this again.
Do you have a driveway or garage floor that needs to be stained, sealed or resurfaced? The unsightly oil stains on these surfaces are not only unattractive but can also cause more serious problems. Learn how to avoid this problem by removing motor vehicle oils from concrete in our helpful guide.
Before we get started, do you want a concrete driveway in Palatine? Check out NGT Concrete.
Remove Excess Oil
Cleaning up motor oil is no easy task. Luckily, there are plenty of ways to get rid of that pesky goo! You can use kitty litter or a rag for wiping off spillages on driveways and sidewalks near your home–just make sure you have enough absorbency before using either option so as not leave any unwanted tracks behind; then later just dispose properly when finished.
Scrub
A deep scrub with paste will take care of most stains while rinsing under running-hot tap might also work if done thoroughly enough; however, one thing is certain – never use chemical solvents such as gasoline since they’ll just leave residues which could lead only worsen matters.
Wash with Soap
Wash your driveway with soap and a scrub brush. Dish detergent will work well on new spots; rinse it off thoroughly before letting dry for good measure.
Power Wash
If you’re looking to remove motor oil from your driveway, power-washing is the best method. The chemical agents in this process will break down any residue on top of or beneath concrete and kill bacteria that could lead to mold growth if left unchecked! You can also use water flush (this sounds gross) – just add bleach solution straight into cracks between paving slabs until they run clear before doing one final rinse with clean water bottle empty at least three times over small area fronting house wall/garage etc.